Supplies Before You Start:
- INKJET Printer (this won’t work with a laser printer)
- Printing Substrate (i.e. T-Shirt, Canvas, etc.)
- Iron or Heat Press
- Hard, Flat surface
- Parchment Paper
- Printable HTV
Printing
- Set the paper type on your printer to “Normal Paper”
- Set the resolution to normal
- Feed single sheets into your printer. This paper CANNOT be multi-fed.
- DO NOT MIRROR your image!
- Print the image.
- Allow to dry for about 5 minutes before transferring.
Preparation
- Make sure to trim ALL excess white areas from around and within your image (an electronic cutting machine like the Cameo and Cricut will make this part a breeze!)
- Prepare a FLAT, solid surface on which to iron…a countertop or sturdy table is great!
- Turn your iron/press on and allow your iron to heat up to full temperature for 4 minutes. *Make sure you have the steam setting turned off
*REMEMBER – You will get the EXACT image on your shirt as you have on the vinyl, including the white background in between lettering and any white edges around your design!
(Recommended) Application – Using a Heat Press
- Preheat your fabric for 3-5 seconds to remove any wrinkles and open up the fibers on your fabric.
- Peel off the grid-lined backing from your transfer.
- Place the transfer paper with the image printed FACE UP on to your fabric.
- Place the parchment paper onto the exposed image to protect the press’ platens from the ink.
- Press with high pressure for 12 seconds at 374°F/190°C
- Wait 1 minute for the transfer to cool before removing the parchment paper.
Application – Using an Iron
- Iron your fabric for 30 seconds, or until it is nicely heated up and smooth of any wrinkles/creases
- Peel off the grid-lined backing from your transfer.
- Place the transfer paper with the image printed FACE UP on to your fabric.
- Place the parchment paper onto the exposed image to protect the iron from the ink.
- Start ironing your image. Make sure ALL AREAS of the image receive the same amount of heat by moving the iron constantly in SMALL CIRCLES and covering all the areas, especially the edges. Apply FIRM and CONSTANT PRESSURE to the Iron. (You can’t put too much pressure on the image – the more the better!)
- Iron for about 2 minutes.
- Once ironed, leave the image to cool for about 1 minute and then remove the parchment paper. The image should be securely adhered to the fabric. If there are any areas that have not adhered well, replace the parchment paper and iron for 1 more minute.
Washing
- Wait 24 hours before washing
- Wash in a washing machine using the FULL SPIN CYCLE
- NOT SUITABLE FOR HAND WASHING or DELICATE CYCLE
- Hang dry
Trouble Shooting
- Some of the image didn’t transfer. – Heat of the iron wasn’t high enough. Ensure the iron is on FULL temperature and that all of the areas of the image are ironed
- The image has not transferred at all and comes off of the fabric – Check that you have peeled off the backing paper that has the gird on it.
- The image has disappeared and there is only the white background visible. – You have placed the image face down on the garment. The image should be facing you and covered with parchment paper before ironing/pressing.
- Image Bleeding when Printing – Ensure that you have selected “Normal Paper” mode and the print quality is set to “Normal” or “Best”. If you still have bleeding, reduce ink saturation by 10-15%.