REFLECTIVE ADHESIVE VINYL

Expressions Vinyl's adhesive reflective vinyl renders exceptional retroreflectivity at night. This calendared film has a permanent adhesive that will bond securely to its substrate (surface) within 48 hrs. *Do not allow the adhesive to freeze during the 48hr. curing period!* Designed mainly for outdoor use on commercial, promotional or decorative applications, it is not recommended for indoor use as it could damage painted surfaces upon removal. Applied properly, reflective vinyl can withstand up to 5 years of outdoor display with only minimal maintenance with a clean, soft cloth. Expressions Vinyl's reflective vinyl is available in 7 colors and 3 different sizes. SHOP NOW!

RECOMMENDED APPLICATIONS:

• Outdoor signage
• Vehicle striping
   

CUT SETTINGS:

• Cricut Explore: 
• Light Cardstock
•  Cricut:
• Speed: High
• Thickness: Medium
• Blade Setting: 3 
• Silhouette Cameo:
• Speed: 7
• Thickness: 6
• Blade Setting: 2

 HOW TO APPLY:

1. Clean your surface- The first thing you will want to do is make sure the surface that you are planning on applying the vinyl to is clean and dry.  The smoother your surface the easier it will be to transfer your vinyl onto, but rougher surfaces like wood, textured walls, etc. will still work.
    
2. Cut your design- You can cut your design by hand or use a craft cutter.  After your design is all cut, remove the excess vinyl from around your image/lettering (this is called weeding).
    
3. Apply your transfer tape- This is the step that a lot of vinyl beginners are unaware of, and yet probably one of the most important in order to not have a stress meltdown when adhering your vinyl to your surface!  Simply place your transfer tape over your vinyl, then take something flat and hard (i.e. credit card, scraper, popsicle stick, etc.) to smooth out any bubbles and to make sure it is securely fastened to the vinyl.  Next you will carefully pull off the backing paper from the vinyl being careful to make sure that the vinyl has transferred to your tape.
    
4.  Adhere design to new surface- With your surface prepared (step 1) you are ready to align your image. Carefully position it onto your project;  once you have it in place, firmly press down and use your scraper to smooth out any bubbles.  Always make sure to start from the center and work out towards the edges, this will press out any bubbles instead of pushing them in.  Once you have your vinyl securely adhered to your surface, take one corner of your transfer tape and slowly pull downwards at an angle.  Run your scraper (credit card, etc.) over the vinyl once applied to get out any remaining bubbles and help secure it to the surface.