Bike Pillow

Hello again everyone, This week I needed to create a trendy bike pillow to add to our red couch.

To get started, I found a bike frame that I liked. I then used the trace tool in the Silhouette to create the image within the program. Once the image was created, it was time to cut it out.

Using the heat transfer vinyl, I had to reverse the image and cut it out backwards so I can iron it on the pillow case. REMEMBER, when using heat transfer vinyl to reverse the image before you cut it out so it will show up the right way when you iron it on.

After ironing it on the pillow case, I had to let the heat transfer cool down before I attempted to remove it. If it doesn't cool down then it will peal up the image before it has enough time to adhere to the pillowcase. Once it was cool, I put the pillow case on the pillow and the project was complete. Here are the following steps in order including the images below.